Legacy Outback Wagon F4-25L SOHC (2000) | Ignition Cable Technical Service Bulletins
Check the high tension cables for carbon tracks (leakage) If leakage is evident, the high tension cables should be replaced and the ignition coil cleaned
(see Figure 2 and refer to Step 3).
Step 3) Ignition Coil Cleaning Procedure (if carbon track is less than 5 mm)
^
If there is any evidence of carbon, clean the surface of the ignition coil using a clean, soft rag dampened with water.
^
Permit the ignition coil to dry.
^
Clean the same area of the ignition coil using a clean soft rag dampened with Isopropyl alcohol.
^
Permit the ignition coil to dry.
Note:
Do not insert the high tension cables until the ignition coil is dry.
PART INFORMATION
The high tension cables for Impreza and Forester have changed to a silicone rubber boot which has a shiny appearance Please note that the part numbers
have not changed The Legacy and Outback high tension cables also have a silicone rubber boot.