Legacy Outback Wagon F4-2.5L SOHC (2000)
^
Engine must not operate.
5. After completion of ABS sequence control, turn ignition switch OFF.
Operational Guidelines Of The ABS Sequence Control With Select Monitor
NOTE:
^
In the event of any trouble, the sequence control may not be operative. In such a case, activate the sequence control, referring to "OPERATIONAL
GUIDELINES OF THE ABS SEQUENCE CONTROL WITH DIAGNOSIS CONNECTOR".
^
When the diagnosis terminal is connected to the diagnosis connector, the sequence control will not operate.
1. Connect select monitor to data link connector under driver's seat instrument panel lower cover.
2. Turn ignition switch ON.
3. Turn select monitor switch ON.
4. Put select monitor to {BRAKE CONTROL} mode.
5. When {Function check sequence} is selected, 'ABS sequence control' will start.
6. The message 'Press Brake Pedal Firmly' is displayed as follows:
1. When using the brake tester, depress brake pedal with braking force of 981 N (100 kg, 221 lb.).
2. When using the pressure gauge, depress brake pedal so as to make the pressure gauge indicate 3,432 kPa (35 kg/cm2, 498 psi).
CAUTION: Do not depress the clutch pedal.
7. When the message "Press YES" is displayed, press YES key.
8. Operation points will be displayed on select monitor.
Conditions For Completion Of ABS Sequence Control
When the following conditions develop, the ABS sequence control stops and ABS operation is returned to the normal control mode.
1. When the speed of at least one wheel reaches 10 km/h (6 MPH).
2. When terminal No. 5 or No. 8 are separated from diagnosis terminals. (When select monitor is not used.)
3. When the brake pedal is released during sequence control and the braking lamp switch is set to off.
4. When brake pedal is depressed after ignition key is turned to ON, and before ABS warning light goes out. (When select monitor is not used.)
5. When brake pedal is not depressed after ignition key is turned to ON, and within 0.5 seconds after ABS warning light goes out. (When select
monitor is not used.)
6. After completion of the sequence control.
7. When malfunction is detected. (When select monitor is used
