Legacy Outback Wagon F4-2.5L SOHC (2000)
1. Install front belt cover.
Tightening torque: ............................................................................................................................. 5+/-1 Nm (0.5O+/-0.1 kg-m, 3.6+/-O.7 ft-lb)
2. Install belt cover (LH).
Tightening torque: ............................................................................................................................. 5+/-1 Nm (0.5O+/-0.1 kg-m, 3.6+/-O.7 ft-lb)
3. Install crankshaft pulley.
4. Install pulley bolt.
To lock crankshaft, use ST.
ST 499977100 CRANKSHAFT PULLEY WRENCH
1. Clean the crankshaft pulley thread using an air gun.
2. Apply engine oil to the crankshaft pulley bolt seat and thread.
3. Tighten the bolts temporarily with tightening torque of 44 N~m (4.5 kg-rn, 33 ft-lb).
4. Tighten the crankshaft pulley bolts.
Tightening torque: ........................................................................................................................ 177+/-5 Nm (18.0+/-0.5 kg-m, 130.2+/-3.6 ft-lb)
5. Confirm that the tightening angle of the crankshaft pulley bolt is 65 degrees or more. If not, conduct the following procedures 1 through 4.
1. Replace the crankshaft pulley bolts and clean them.
Crankshaft pulley bolt: 12369AA011
2. Clean the crankshaft thread using an air gun.
3. Tighten the bolts temporarily with tightening torque of 44 Nm (4.5 kg-m, 33 ft-lb).
4. Tighten the crankshaft pulley bolts keeping them in an angle between 65° and 75°.
CAUTION: Conduct the tightening procedures by confirming the turning angle of the crankshaft pulley bolt referring to the gauge
indicated on the belt cover.
