Legacy Outback Wagon F4-2.5L SOHC (2000)
3. Connect battery ground cable and turn ignition switch "ON" (engine off) to make sure airbag warning light illuminates.
CHECK: Does the airbag warning light come on?
YES:
Go to step 5AA4.
NO:
Replace airbag warning light bulb or combination meter printed circuit.
5AA4: AIRBAG MAIN HARNESS INSPECTION
1. Turn ignition switch "OFF", disconnect battery ground cable and then wait at least 20 seconds.
2. Connect body harness connector (B31) and connector (AB1).
3. Disconnect connector (AB6) from airbag control module.
4. Connect battery ground cable and turn ignition switch "ON" to make sure airbag warning light illuminates.
CHECK: Does the airbag warning light come on?
YES:
Replace airbag control module.
NO:
Replace airbag main harness.
