Legacy Outback Wagon F4-2.5L SOHC (2000)
5K12: FRONT SUB SENSOR HARNESS (RH) INSPECTION
1. Connect test harness F connector (1F) and connector (AB15).
2. Disconnect connector (AB16) from front sub sensor (RH) and then test harness H connector (1H) and connector (AB16).
3. Measure resistance between test harness F connector (3F) terminal and test harness H connector (3H) terminal.
CHECK: Is the resistance less than 10 ohms?
YES:
Go to step 5K13.
NO:
Replace front sub sensor harness (RH).
5K13: FRONT SUB SENSOR HARNESS (RH) INSPECTION
Measure resistance between test harness F connector (3F) terminal and test harness H connector (3H) terminal.
CHECK: Is the resistance less than 10 ohms?
YES:
Go to step 5K14.
NO:
Replace front sub sensor harness (RH).
5K14: FRONT SUB SENSOR HARNESS (RH) INSPECTION
Measure resistance across test harness F connector (3F) terminal and chassis ground.
CHECK: Is the resistance more than 10 K ohms?
YES:
Go to step 5K15.
NO:
Replace front sub sensor harness (RH).
5K15: FRONT SUB SENSOR HARNESS (RH) INSPECTION
