Legacy Outback Wagon F4-2.5L SOHC (2000)
Roll Connector: Service and Repair
REMOVAL
1. Turn ignition switch off.
2. Disconnect ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove lower cover.
Disconnect airbag connector (AB3) and (AB8) below steering column.
CAUTION: Do not reconnect airbag connector at steering column until combination switch is securely reinstalled.
4. Disconnect combination switch connectors from body harness connector
5. Set front wheels in straight ahead position.
Using T30 TORX© bit, remove two TORX© bolts.
6. Disconnect airbag connector on back of airbag module. Remove airbag module, and place it with pad side facing upward.
7. Using steering puller, remove steering wheel.
