Legacy Outback Wagon F4-2.5L SOHC (2000)
CAUTION:
-
Install bushing with painted side facing up.
-
Install front bushing in the proper direction, as shown in figure.
2. REAR BUSHING
1. Using ST-C, D and bearing puller, press bushing into trailing link.
ST-C, D 20099AE040 INSTALLER & REMOVER SET
1. Insert bushing into bore in ST-D.
2. Set ST-C, ST-D and bearing puller in position, as shown in the figure, and press
E: INSTALLATION
1. Use a transmission jack to support the rear arm.
2. Install rear arm and temporarily tighten bolts securing rear arm to links.
3. Install bearing unit.
4. Install bolt securing ABS sensor to rear arm.
5. Install bolt securing brake hose to rear arm.
6. Install bolt securing parking brake cable clamp to rear arm.
7. Place jack (furnished with vehicle) upside down and position it between link rear and sub frame. Adjust jack position so rear shock absorber is
aligned with rear arm at their corresponding holes. Install lower shock absorber bolts.
CAUTION: Put a cloth between jack and its mating area to protect link rear and sub frame from scratches.