Legacy Outback Wagon F4-2.5L SOHC (2000)
3. Remove bolt securing link front to sub frame.
4. Remove bolts which secure link front to rear arm and detach link front.
NOTE: Link front bushing cannot be replaced alone. Always replace link front and bushing as a single unit.
B: INSPECTION
Visually check link front for damage or bends.
C: INSTALLATION
To install, reverse removal procedures, observing the following instructions.
CAUTION:
-
Using transmission jack, support rear arm horizontally, install link front and tighten nuts to specified torque.
-
Install link front with protruded side facing front.
-
Replace self-locking nut.
NOTE: Check wheel alignment and adjust if necessary.
9. Link Rear
A. REMOVAL
