Legacy Outback Wagon F4-2.5L SOHC (2000)
Differential Clutch: Technical Service Bulletins
A/T - Revised Transfer Clutch Assembly
NUMBER: 16-64-99
DATE: 09-15-99
APPLICABILITY:
All Legacy, Impreza, Forester and SVX vehicles with AWD 4EAT Transmissions
SUBJECT:
Revised Transfer clutch assembly replacement procedures
This information is to be used in conjunction with Parts Bulletin number 07-03-99 dated February 12, 1999. The updated components described in this
Service Bulletin have been incorporated into all 1999 Model Year and later 4EAT automatic transmissions (models with spin-on oil filter).
In the past, when performing the transfer clutch overhaul, the friction and steel plates were sold as a set. The selective pressure plate used to set the
clutch pack end clearance was ordered individually as a separate component. Now, when replacement of the transfer clutch is necessary, you will need to
measure the thickness of the end plate that is being removed from the worn clutch pack (3.3, 3.7, 4.1, or 4.5 mm) and order the appropriate clutch pack
assembly based on the chart shown.
When installing the new clutch pack, do not disassemble it to soak the friction plates prior to installation as in the past. Some ATF should be used during
assembly for lubrication purposes. It is important that the new plates be kept in the order that they are shipped as they are "broken in" during the
manufacturing process prior to packaging. After installation into the clutch drum, make sure the end clearance measurement is within the proper
specification as outlined in the Service Manual or repeat the above procedures until the proper clearance is obtained.
