Legacy Outback Wagon F4-2.5L SOHC (2000)
10) Remove hub unit bearing.
CAUTION: Be careful not to damage tone wheel. If it is hard to remove, use STs
ST1 926470000 AXLE SHAFT PULLER
ST2 927140000 PLATE
2. DRUM BRAKE
1) Disconnect ground cable from battery.
2) Jack-up vehicle, and remove rear wheel cap and wheels.
CAUTION: Be sure to loosen and retighten axle nut after removing wheel from vehicle. Failure to follow this rule may damage wheel bearings.
3) Unlock axle nut.
4) Remove axle nut using a socket wrench.
5) Return parking brake lever.
6) Remove brake drum from hub.
7) If it is difficult to remove brake drum, turn adjusting screw using a slot-type screwdriver until brake shoe separates from the drum.
NOTE: If brake drum is difficult to remove, drive it out by installing an 8-mm bolt into bolt hole in brake drum.
8) Remove ABS sensor.
