Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
7) Turn crankshaft pulley clockwise until arrow mark on camshaft sprocket is set to position shown in figure.
8) Ensure that #1 cylinder intake valve and #3 cylinder exhaust valve are adjusted to specifications.
CAUTION:
^
Insert the thickness gauge in as horizontal a direction as possible with respect to the shim.
^
Adjust exhaust valve clearances while lifting-up the vehicle.
Valve clearance:
Intake: 0.20 ± 0.02 mm (0.0079 ± 0.0008 inch)
Exhaust: 0.25 ± 0.02 mm (0.0098 ± 0.0008 inch)
9) Turn crankshaft two complete rotations. Check again to ensure that #1 cylinder intake valve and #3 cylinder exhaust valve clearances are within
specifications. If necessary, re-adjust valve clearances.
10) Further turn crankshaft pulley clockwise. Using the same procedures as in two steps before, measure valve clearances.
1) Set arrow mark on camshaft sprocket to position shown in figure, and check #2 cylinder exhaust valve and #3 cylinder intake valve clearances.
2) Set arrow mark on camshaft sprocket to position shown in figure, and check #2 cylinder intake valve and #4 cylinder exhaust valve clearances.
