Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
Evaporator Case: Service and Repair
Disassembly and Assembly
Evaporator Module
DISASSEMBLY AND ASSEMBLY
1. Remove resistor assembly (1) and remove six screws from evaporator case.
2. Remove thermostat (1) from upper case. (Thermistor (2) is inserted into specified evaporator fin position.) When installing thermostat, be sure to
insert thermistor into specified fin position.
3. Disconnect the connection between the expansion valve and pipe from receiver drier.
4. Remove the expansion valve from pipes.
5. To install expansion valve, reverse removal procedures. Properly wrap capillary tube of expansion valve with seal.
6. Check to see if the evaporator fins are clogged. If they are, clean them with compressed air.
CAUTION: Water must never be used to clean the evaporator.
7. Check parts that have been removed for cracks or scratches, and repair or replace them with new ones, if necessary.
8. Reassemble the evaporator in the reverse order of disassembly.
NOTE: Confirm that the O-ring is inserted in the specified position.
