Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
8. Tighten air bleeder securely when no air bubbles are visible.
Air bleeder tightening torque: 8 ± 1 Nm (0.8 ± 0.1 kg-m, 5.8 ± O.7 ft. lbs.)
9. Bleed air through rear LH and RH caliper by operating brake pedal. This is the same procedure as step 3.
10. Tighten air bleeders securely when bubbles are visible.
Air bleeder tightening torque: 8 ± 1 Nm (0.8 ± 0.1 kg-m, 5.8 ± 0.7 ft. lbs.)
11. Operate FRO (Front Right Outlet) valve and RLO (Rear Left Outlet) valve to bleed air from hydraulic unit outlet circuit.
1. Press TCS OFF switch while depressing brake pedal.
2. Make sure ABS warning light illuminates.
3. Repeatedly depress and release brake pedal 10 times or more while pressing TCS OFF switch.
NOTE:
-
Air comes out from reservoir tank.
-
Repeat the above procedures until air no longer comes out of reservoir tank.
12. Operate FLO (Front Left Outlet) valve and PRO (Rear Right Outlet) valve to bleed air from hydraulic unit outlet circuit.
1. Press TCS OFF switch while depressing brake pedal.
2. Make sure TCS warning light illuminates.
3. Repeatedly depress and release brake pedal 10 times or more while pressing TCS OFF switch.
NOTE:
-
Air comes out from reservoir tank.
-
Repeat the above procedures until air no longer comes out of reservoir tank.
-
The operations in steps 4, 6, 11 and 12 above can be switched each other by operating brake pedal (stop light switch).
13. Perform these steps for the brakes connecting to the secondary chamber of master cylinder, first, and then for the ones connecting to primary
chamber. With all procedures completed, fully depress the brake pedal and keep it in that position for approximately 20 seconds to make sure
that there is no leak evident in the entire system.
14. Turn ignition switch OFF.
15. Perform TCS sequence control.
16. Check the pedal stroke.
While the engine is idling, depress the brake pedal with a 490 N (50 kg, 110 lbs.) load and measure the distance between the brake pedal and
steering wheel. With the brake pedal released, measure the distance between the pedal and steering wheel again. The difference between the
two measurements must be more than specified.
Specified pedal stroke: 95 mm (3.74 inch)
When depressing brake pedal with a 490 N (50 kg, 110 lbs.) load.
If the distance is more than specifications, there is a possibility air is in the inside of the brake line. Bleed air from the brake line.
17. Turn ignition switch OFF.
18. Disconnect select monitor or diagnosis terminal.
19. Add brake fluid to the required level (MAX. level) of reserve tank.
20. As a final step, test run the vehicle at low speed and apply brakes relatively hard 2 to 3 times to ensure that brakes provide normal braking
action on all four wheels without dragging and uneven braking.