subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Recall - Engine Oil Filter Inspection/Replacement|Page 795 > < Recall - Engine Oil Filter Inspection/Replacement|Page 793
Page 7
background image

Replacement Subaru oil filters are already in inventory at dealerships. Oil filters produced before or after the "lot numbers" listed in this bulletin can be
used as replacement parts for this campaign. For quicker service, it is recommended that dealers order oil filters in carton pack quantities of 12 and the
drain plug gaskets in pack quantities of 5.

PARTS PRICING

SERVICE PROCEDURE

Inspect the engine oil filter "lot number" as follows:

1.

Raise the vehicle on a lift.

2.

Inspect the oil filter "lot number" on the side of the oil filter (see figure 1). The use of an inspection mirror may be necessary to see the "lot
number" on some models or with some accessory equipment installed.

3.

If the "lot number" on the oil filter is one of the following or it cannot be determined (worn off), replace the oil filter and change the customer's oil.

F01 J21D2
F01 J30D2
F02 J09D1
F02 J09D2
F02 J20D1

If the "lot number" is not listed above, no further action is required.

CLAIM REIMBURSEMENT AND ENTRY PROCEDURES

A recall/campaign control number is required for submission of any recall/campaign claim.

Control numbers for recalled vehicles identified in the affected VIN range (Chart 1) may be obtained by performing a vehicle coverage inquiry through
the dealer DCS system.

Recall - Engine Oil Filter Inspection/Replacement|Page 795 > < Recall - Engine Oil Filter Inspection/Replacement|Page 793