Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
Impact Sensor: Component Tests and General Diagnostics
Inspection and Replacement Standards
A: VEHICLES WHICH BECOME INVOLVED IN A COLLISION
If the vehicle equipped with an SRS airbag system is damaged in a collision, the airbag system parts must be checked and replaced in accordance with
the following standards:
-
After faulty parts are replaced, the warning light operation must be checked.
-
When the ignition switch is turned ON, it lights up for about 7 seconds and then it goes out for at least 30 seconds.
-
The trouble code stored in memory must be erased after the check.
B: FRONT SUB SENSOR
1. INSPECTION STANDARD
-
Check the front section (Refer to shaded area of vehicle in figure) for damage, regardless of whether or not airbag is deployed.
-
The designated trouble code is output during self-diagnosis.
2. REPLACEMENT STANDARD
-
Bracket is deformed.
-
Housing is cracked or deformed.
-
The label (that identifies the manufacturing number) is peeled or deteriorated.
-
Harness circuit is broken, lead wire is exposed, corrugated tube is cracked, etc.
-
Front sub sensor determined as faulty as a result of Diagnostics.
-
Airbag is deployed.
-
Front sub sensor dropped to the floor/ground.
C: SIDE AIRBAG SENSOR
1. INSPECTION STANDARD
-
Check the side section (Refer to shaded area of vehicle in figure) for damage, regardless of whether or not airbag is deployed.
-
The designated trouble code is output during self-diagnosis.
2. REPLACEMENT STANDARD
-
Bracket is deformed.
-
Housing is cracked or deformed.
-
The label (that identifies the manufacturing number) is peeled or deteriorated.
-
Harness circuit is broken, lead wire is exposed, corrugated tube is cracked, etc.
-
Side airbag sensor determined as faulty as a result of Diagnostics.
-
Airbag is deployed.
-
Side airbag sensor dropped to the floor/ground.
