Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
4. Install front ABS sensor on strut and wheel apron bracket.
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
5. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire
perimeter, tighten ABS sensor on housing to specified torque.
ABS sensor standard clearance: 0.9 - 1.4 mm (0.035 - 0.055 inch)
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
CAUTION: Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)
NOTE: If the clearance is outside specifications, readjust.
Rear ABS Sensor
1. Install rear tone wheel on hub, then rear housing on hub.
2. Temporarily install rear ABS sensor on back plate.
CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.
3. Install rear drive shaft to rear housing and rear differential spindle.
4. Install rear sensor harness on rear trailing link.
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
5. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire
perimeter, tighten ABS sensor on back plate to specified torque.
ABS sensor standard clearance: 0.7 - 1.2 mm (0.028 - 0.047 inch)
Tightening torque: 32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
