subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Recall - Front Spring Guard Update|Page 4559 > < Recall - Front Spring Guard Update|Page 4550
Page 1
background image

Suspension Strut / Shock Absorber: All Technical Service Bulletins
Recall - Front Spring Guard Update

NUMBER: WWE-88R

DATE: 01/2002

APPLICABILITY:
1995~1999MY Subaru Legacy and Outback Vehicles

SUBJECT:
Front Spring Guard Bulletin Update

DESCRIPTION

The following information supplements the WWE-88 "Front Spring Guard Bulletin" released in September 2001.

After-market Replacement Struts

It has been determined that Front Spring Guards may not properly fit on vehicles equipped with some non-OE (after-market) replacement front struts. In
cases where it is not possible to install the Front Spring Guards, it will be necessary to install new OE replacement front springs. In these cases,
replacement of the front springs will be covered by the recall and eliminate the need to install Front Spring Guards in order to complete the WWE-88
recall.

The vehicle owner should be advised that the front springs were replaced as an alternate repair method because the vehicle had non-OE (after-market)
replacement front struts and the Front Spring Guards would not properly fit.

Replacement of after-market front struts with new O.E. struts, in order to install Front Spring Guards, will not be covered by this recall.

For claim entry, follow claim submission procedure 2 outlined in the original campaign bulletin.

Revised VIN Range

SOA has determined that the VIN range for 1996 Legacy sedans was published incorrectly. The correct VIN range is T*200001 - T*213040. Owners of
affected vehicles within all VIN ranges have been notified.

Recall - Front Spring Guard Update|Page 4559 > < Recall - Front Spring Guard Update|Page 4550