Legacy Postal Wagon AWD F4-2.2L SOHC (1998)
Constant Velocity Joint Boot: Service and Repair
Front SFJ, DOJ and BJ Boots
A: REMOVAL
1) Disconnect ground cable from battery.
2) Jack-up vehicle, support it with safety stands (rigid racks), and remove front wheel cap and wheels.
NOTE: Do not remove axle nut.
3) Remove stabilizer link.
4) Disconnect transverse link from housing.
5) Remove spring pin which secures transmission spindle to DOJ/SFJ.
CAUTION: Use a new spring pin.
6) Remove SFJ, DOJ and BJ boots from drive shaft.
B: INSTALLATION
1) Install SFJ, DOJ and BJ boots to drive shaft.
2) Install DOJ/SFJ on transmission spindle and drive spring pin into place.
CAUTION: Always use a new spring pin.
3) Connect transverse link to housing.
4) Install stabilizer link.
