subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Flywheel|Specifications|Page 3684 > < Flywheel|Specifications|Page 3682
Page 2
background image

2. Hardened facing 

Correct by using emery paper or replace. 

3. Oil soakage on facing 

Replace clutch disc and inspect transmission front oil seal, transmission case mating surface, engine rear oil seal and other points for oil leakage.

4. Deflection on facing 

If deflection exceeds the specified value at the outer circumference of facing, repair or replace.
Limit for deflection: 1.0 mm (0.039 inch) at R = 107 mm (4.21 inch)

5. Worn spline, loose rivets and torsion spring failure Replace defective parts.

CLUTCH COVER 

Visually check for the following items without disassembling, and replace or repair if defective.
1. Loose thrust rivet.
2. Damaged or worn bearing contact area at center of diaphragm spring.

Flywheel|Specifications|Page 3684 > < Flywheel|Specifications|Page 3682