Legacy Wagon 4WD F4-2.5L DOHC (1996)
8) Loosen bolts which secure tone wheel to hub. Remove tone wheel (only vehicle equipped with A.B.S.).
9) Using ST and a hydraulic press, drive hub bolts out. ST 927080000 HUB STAND
CAUTION: Be careful not to hammer hub bolts. This may deform hub.
Inspection
C: INSPECTION
Check the removed parts for wear and damage. If defective, replace with new ones.
CAUTION:
-
If bearing is faulty, replace it as a bearing set.
-
Be sure to replace oil seal at every overhaul.
Assembly
D: ASSEMBLY
1) Attach hub to ST securely. ST 927080000 HUB STAND
2) Using a hydraulic press, press new hub bolts into place.
CAUTION: Be sure to press hub bolts until their seating surfaces contact the hub.
NOTE: Use 12 mm (0.47 in) dia. holes in HUB STAND to prevent bolts from tilting.
3) Remove foreign particles (dust, rust, etc.) from mating surfaces of hub and tone wheel, and install tone wheel to hub (only vehicle equipped
