Loyale Sedan (4 Door) 4WD F4-1781cc 1.8L SOHC (1989)
Liquid Vapor Separator: Service and Repair
Fuel Separator Replacement
FUEL SEPARATOR
Removal
1.
Remove right trim panel from luggage compartment.
2.
Remove hose protector.
3.
Remove fuel separator and bracket as a unit.
4.
Disconnect evaporation hose from pipe connected to bracket.
5.
Remove fuel separator from bracket.
6.
Disconnect hose from separator.
Installation
Reverse removal procedures and observe the following:
1.
Install the hose between fuel separator and pipe until it stops against nipple on the separator side and push the other end up to the marked position
on the pipe side.
2.
Install fuel separator on the bracket so that the pipe can run through the relieved section of the separator.
3.
Install the evaporation tube 15 to 20 mm (0.59 to 0.79 in) onto the pipe on the bracket. Install clamps so they do not touch any other hoses.