Outback F4-2.5L (2008)
Radio/Stereo Noise Filter: Service and Repair
Noise Suppressor
REMOVAL
1. SEDAN MODEL
1. Disconnect the ground cable from the battery.
2. Remove the rear quarter trim.
3. Remove the curtain airbag module.
4. Disconnect harness connector from the noise suppressor.
5. Remove the harness clip.
6. Remove the screws and detach the noise suppressor.
2. WAGON MODEL
1. Disconnect the ground cable from the battery.
2. Remove the rear gate trim.
3. Disconnect harness connector from the noise suppressor.
4. Remove the screws and detach the noise suppressor.
INSTALLATION
Install in the reverse order of removal.