Outback F4-25L (2008) - Electronic Brake Control Module Service & Repair | ABS - Page 50
Electronic Brake Control Module: Service and Repair
With VDC
VDC Control Module and Hydraulic Control Unit (VDCCM & H/U)
REMOVAL
1) Disconnect the ground cable from the battery.
2) Use compressed air to remove moisture and dust around the VDCCM & H/U.
NOTE: If the terminals become dirty, it may cause improper contact.
3) Lift the lock lever and Disconnect the VDCCM & H/U connector.
CAUTION: Do not pull on the harness when disconnecting the connector.
4) Disconnect the brake pipes from the VDCCM & H/U.
5) Wrap the brake pipe with a vinyl bag so as not to spill the brake fluid on the vehicle body.
CAUTION: If brake fluid is spilled on the vehicle body, wash it off immediately with water and wipe clean.
6) Remove the nuts and remove the VDCCM & H/U.
CAUTION:
^
Do not drop or bump the VDCCM & H/U.
^
Do not turn the VDCCM & H/U upside down or place it sideways during storage.
^
Be careful not to let foreign matter enter the VDCCM & H/U.
^
Be careful that no water enters the connectors.
7) Remove the VDCCM & H/U bracket.
INSTALLATION
1) Install the VDCCM & H/U bracket.
Tightening torque: 33 N-m (3.4 kgf-m, 24 ft-lb)
2) Install the VDCCM & H/U with a new nut (Part No. 023506000) by aligning the damper groove of the VDCCM & H/U to the bracket side claw.