Outback F4-2.5L (2008)
4) Fill the 3 locations of the transmission case excluding the bolt holes with liquid gasket.
Liquid gasket: THREE BOND 1217B (Part No. K0877YA020) or equivalent
5) Install the oil pan by equally tightening the bolts.
Tightening torque: 5 N-m (0.5 kgf-m, 3.6 ft-lb)
6) Install the front vehicle speed sensor and torque converter turbine speed sensor.
Tightening torque: 7 N-m (0.7 kgf-m, 5.1 ft-lb)
7) Connect the connector to the rear vehicle speed sensor.
8) Install the ATF inlet and outlet pipes.
NOTE: Use a new copper washer.
9) Install the transmission rear crossmember bolt.
Tightening torque: 75 N-m (7.6 kgf-m, 55.3 ft-lb)
10) Install the propeller shaft.
11) Install the heat shield cover.
12) Install the front, center and rear exhaust pipes, and the muffler.
13) Lower the vehicle.
14) Install the transmission harness connector to the stay.
