Outback F4-2.5L (2008)
3) Connect the clutch switch connector.
4) Make sure that engine does not start with clutch pedal not depressed.
5) Make sure that engine starts with clutch pedal fully depressed.
INSPECTION
1) Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the starter interlock
circuit.
2) Make sure that engine starts with clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the starter interlock
circuit.
3) Check the clutch switch for continuity. If the resistance is not at the standard value, replace the switch.
(1)
Disconnect the clutch switch connector.
(2)
Measure the resistance between terminal 1 and 2 of the switch.
Clutch switch (Clutch start)
Clutch switch (Cruise control)
