Outback F4-2.5L (2008)
Power Steering Pump: Removal and Replacement
Oil Pump
REMOVAL
H4 MODEL
1) Disconnect the ground cable from the battery.
2) Remove the air intake duct.
3) Remove the pulley belt cover.
4) Loosen the belt tension securing bolt and generator securing bolt, then remove the power steering pump V-belt.
5) Disconnect the connector from the power steering pressure switch.
6) Disconnect the pressure hose and suction hose from the oil pump.
CAUTION:
^
Do not allow fluid to come into contact with the pulley belt.
^
To prevent foreign matter from entering the hose and pipe, cover the open ends with clean cloth.
^
Non-turbo model
^
Turbo model
