Outback F4-2.5L (2008)
36) Remove the gearbox from ST.
ST1 926200000 STAND
ST2 34199AG000 BOSS D
37) Install the four pipes on gearbox.
(1)
Connect the pipes A and B to the four pipe joints of gearbox.
Tightening torque: Refer to the component parts.
(2)
Connect the pipes C and D to gearbox.
2. CONTROL VALVE ASSEMBLY
Specified steering grease: VALIANT GREASE M2 (Part No. 003608001)
1) Clean all parts and tools before reassembling.
2) Apply a coat of specified power steering fluid to the inner wall of valve housing.
3) To avoid scratching the oil seal, apply a coat of grease to the contact surface of installer and oil seal.
4) Verify the direction of oil seal. Install the oil seal to installer and position it to valve housing.
5) Press the oil seal into position using press.
ST 34199AG090 INSTALLER & REMOVER
