Outback F4-2.5L (2008)
Fluid - A/T: Service and Repair
A/T Fluid Inspection
INSPECTION
NOTE: The level of ATF varies with fluid temperature. Pay attention to the ATF temperature when checking ATF level.
1) Raise the ATF temperature by driving a distance of 5 to 10 km (3 to 6 miles). Otherwise, idle the engine to raise ATF temperature to 70 - 80°C
(158 - 176°F) on Subaru Select Monitor.
2) Park the vehicle on a level surface.
3) After selecting all positions (P, R, N, D), set the select lever in "P" range. Idle the engine for 1 or 2 minutes, and measure the ATF level.
4) Make sure that the ATF level is between upper and lower marks of the HOT side.
If the fluid level is below the lower mark, check the transmission for leaks. If there are leaks, it is necessary to repair or replace gaskets, oil seals, plugs
or other parts.
5) If the ATF level is below the center point between upper and lower level marks, add the recommended ATF until the fluid level is above the center
point between the upper and lower level marks.
CAUTION:
^
Be careful not to exceed the upper level.
^
If ATF is added to the upper level while the transmission is cool, there will be too much ATF and will cause problems. Do not exceed the
upper level.
6) Check ATF level after raising ATF temperature to 70 - 80°C (158 - 176°F) by running the vehicle again or by idling the engine.
