Outback F4-2.5L (2008)
Pressure Plate: Service and Repair
Clutch Disc and Cover
REMOVAL
NOTE: The illustration below is for a 5MT non-turbo model. However, perform the same procedures for models other than 5MT non-turbo model as
well.
1) Remove the transmission assembly from vehicle body.
2) Insert the ST on the flywheel.
ST 499747100 CLUTCH DISC GUIDE
3) Remove the clutch cover and clutch disc.
NOTE:
^
Take care not to allow oil to touch the clutch disc face.
^
Do not disassemble the clutch cover or clutch disc.
INSTALLATION
NOTE: The illustration below is for a 5MT non-turbo model. However, perform the same procedures for models other than 5MT non-turbo model as
well.
1) Insert the ST into the clutch disc and attach to the flywheel by inserting the ST end into pilot bearing.
NOTE: When installing the clutch disc, be careful to attach in the correct direction.
ST 499747100 CLUTCH DISC GUIDE
2) Install the clutch cover to the flywheel and tighten the bolts to the specified torque.
NOTE:
^
When installing the clutch cover to the flywheel, position the clutch cover so that the distance between unbalance marks - paint marks) is at least
120°. (The unbalance marks - indicate the directions of residual unbalance.)
^
Note the front and rear of the clutch disc when installing.
^
Tighten the clutch cover installing bolts gradually. Each bolt should be tightened to the specified torque in a crisscross order.
