Outback F4-2.5L (2008)
Gear Sensor/Switch: Service and Repair
REMOVAL
BACK-UP LIGHT SWITCH & NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the air intake chamber and intake boot. (Non-turbo model)
3) Remove the intercooler. (Turbo model)
4) Disconnect the connector back-up light switch & neutral position switch.
^
Non-turbo model
^
Turbo model
5) Lift up the vehicle.
6) Remove the back-up light switch & neutral position switch with the harness.
INSTALLATION
BACK-UP LIGHT SWITCH & NEUTRAL POSITION SWITCH
1) Install the back-up light switch & neutral position switch with the harness.