Outback F4-2.5L DOHC Turbo (2006)
Sunroof / Moonroof Motor: Service and Repair
Sunroof Motor
REMOVAL
CAUTION:
-
When removing the clip, use great care not to damage the roof trim.
-
Never rotate the sunroof motor after removing it.
1. SEDAN MODEL
1. Completely close the glass lid.
2. Disconnect the ground cable from battery.
3. Remove the spot map light.
4. Disconnect the harness connector, and then remove the motor assembly mounting screw.
CAUTION: When removing the motor assembly, secure the cable wires to prevent moves.
2. WAGON MODEL
1. Fully close the glass lid (front) and glass lid (rear).
2. Disconnect the ground cable from battery.
3. Remove the luggage room light.
4. Remove the roof trim.
5. Pass the seat belt tongue located on center of rear seat through the hole, and then pull it out to the opposite side of trim.
6. Remove the clips, and then drop the rear end of roof trim.