Outback F4-2.5L DOHC Turbo (2006)
9. Using TORCH bit E5, tighten the screws stepwise in the order of (1) through (4).
CAUTION: Always use new screws.
10. Check that there is no foreign matter in aligning part between ABSCM and H/U.
11. Using TORX (R) bit E5, tighten the screws stepwise in the order of (1) through (4) again.
Tightening torque: 3 Nm (0.3 kgf-m, 2.2 ft. lbs.)
12. Check that there is no clearance in aligning part between ABSCM and H/U.
13. Install the ABSCM&H/U to vehicle.
