Outback F4-2.5L DOHC Turbo (2006)
4. Remove the sensor harness bracket.
5. Remove the bolts which secure the sensor harness to the front strut.
6. Remove the front ABS wheel speed sensor from housing.
CAUTION:
^
Be careful not to damage the sensor.
^
Do not apply excessive force to the sensor harness.
INSTALLATION
Install in the reverse order of removal.
Tightening torque:
Sensor. 7.5 Nm (0. 76 kgf-m, 5.5 ft. lbs.)
Bracket. 33 Nm (3.3 kgf-m, 24 ft. lbs.)
CAUTION: Be careful not to damage the sensor.
NOTE:
^
Check the identification (mark) on the harness to make sure there is no warpage. (RH: K1 (White), LH: K2 (Yellow))
^
Check if the harness is not pulled and does not come in contact with the suspension or body during steering wheel effort.
INSPECTION
CHECK WITH SUBARU SELECT MONITOR
1. Connect the Subaru Select Monitor to the data link connector.
2. Select (Current Data Display & Save). Check if the speed indicated on the display changes in the same manner as the speedometer reading during
acceleration/deceleration when the steering wheel is in the straight-ahead position.