subaru Workshop Repair Guides

Subaru Workshop Service and Repair Manuals

Engine Controls - Cooling Fan Runs Continuously|Page 2858 > < Engine Controls - Cooling Fan Runs Continuously
Page 1
background image

Engine Control Module: Customer Interest
Engine Controls - Cooling Fan Runs Continuously

NUMBER: 09-43-06 
DATE: 08/02/06

APPLICABILITY: 
2005MY and After Legacy and Outback 
Vehicles Equipped with 2.5 Turbo SMI

SUBJECT:
Modification of Main Cooling Fan Relay

INTRODUCTION

The purpose of this bulletin is to inform you of a modification made to the main cooling fan relay.

The negative surge current protector in the relay was changed from a diode to a resistor, in order to protect the ECM circuitry. If the ECM circuitry gets
damaged it could cause the main cooling fan to run continually.

When diagnosing an applicable vehicle for a main cooling fan running continually, follow the normal diagnostic procedures. If nothing is found, and the
vehicle is before the countermeasure~ replace the ECM and install a modified relay.

PRODUCTION LINE CHANGE

The modified relay was used in production May, 2006 starting with the VINs shown.

PART INFORMATION

The new part number for the modified main cooling fan relay is 82501AG120.

WARRANTY/CLAIM INFORMATION

Refer to the Subaru Warranty Wizard for claim submission information.

Disclaimer

Engine Controls - Cooling Fan Runs Continuously|Page 2858 > < Engine Controls - Cooling Fan Runs Continuously