Outback F4-2.5L DOHC Turbo (2006)
Camshaft Position Sensor: All Technical Service Bulletins
Engine Controls - DTC P0340/P0345 After Camshaft R & R
Number: 02-107-09
Date: 03/24/09
Applicability:
2004~06MY Baja 2.5L Turbo
2004~06MY Impreza 2.5L Turbo
2004~06MY Forester 2.5L Turbo
2004~06MY Legacy/Outback 2.5L Turbo
SUBJECT:
Intake Camshaft Replacement
Introduction
If you encounter a vehicle that has a CEL and P0340 or P0345 stored in memory immediately after replacing the intake camshaft(s), the air gap between
the camshaft and camshaft position sensor may be out of specification. A modification was made to the plate area of the camshaft where the camshaft
position sensor picks up the signal.
Parts Information
Repair Procedure/ Information
Using a feeler (thickness) gauge, measure the gap between the camshaft and camshaft position sensor.
The correct gap is between 0.15mm to 0.98mm (0.0059 to 0.0386 in.) If the gap is over 0.98mm (0.0386 in.) replace the camshaft position sensor. Refer
to the applicable service manual.
Warranty/Claim Information
For vehicles within warranty, refer the Subaru Warranty Wizard for claim submission information.
