Outback F4-2.5L DOHC Turbo (2006)
-
When painting or performing sheet metal work on the side of the vehicle, including the side sill, center pillar, and front and rear doors, remove the
side airbag sensors and wire harness of airbag system.
-
After removal, keep each airbag system part with the pad facing upward on a dry, clean and flat surface away from heat, light sources, moisture
and dust.
-
When airbag control module, front sub sensor, side airbag sensor and curtain airbag sensor are removed, do not reuse the bolts and nuts of them.
Always use new bolts and nuts for them.
