Outback F4-2.5L DOHC Turbo (2006)
Camshaft Position Sensor: Service and Repair
Camshaft Position Sensor
REMOVAL
1. Remove the collector cover.
2. Disconnect the ground cable from battery.
3. Disconnect the connector from camshaft position sensor RH.
4. Remove the camshaft position sensor RH from the rear side of cylinder head.
5. Remove the camshaft position sensor LH in the same procedure as RH.
INSTALLATION
Install in the reverse order of removal.
Tightening torque: 6.4 N.m (0.65 kgf-m, 4.7 ft-lb)