Outback F4-2.5L DOHC Turbo (2006)
Shift Cable: Service and Repair
Select Cable
REMOVAL
1. Set the vehicle on a lift.
2. Shift the select lever to "N" range.
3. Disconnect the ground cable from battery.
4. Lift up the vehicle.
5. Remove the front, center and rear exhaust pipes and the muffler. (SOHC and DOHC non-turbo model)
6. Remove the center and rear exhaust pipes and the muffler.
7. Remove the heat shield cover.
8. Remove the snap pin and washer from range select lever.
9. Remove the plate assembly from the transmission case.