Outback F4-2.5L DOHC Turbo (2006)
Clutch Switch: Service and Repair
Clutch Switch
REMOVAL
1. Disconnect the ground cable from battery.
2. Remove the instrument panel lower cover.
3. Disconnect the connector from clutch switch.
4. Remove the clutch switch.
INSTALLATION
CLUTCH SWITCH (WITH CRUISE CONTROL)
1. Install the clutch switch and clutch pedal stopper so that the gap between them is 0 mm (0 inch).
Tightening torque: 8 Nm (0.8 kgf-cm, 5.8 ft. lbs.)
2. Measure the stroke of the clutch pedal.
Specified clutch pedal full stroke: A
Non-turbo model 130-135 mm (5.12-5.31 inch)
Turbo model 135-140 mm (5.31-5.51 inch)
3. If the clutch pedal stroke is out of specification, adjust the stroke.
4. Connect the clutch switch connector.
CLUTCH SWITCH (STARTER INTERLOCK)
1. Fully depress the clutch pedal.