Outback F4-2.5L DOHC Turbo (2006)
7. Install the wheel.
Tightening torque: 110 Nm (11.2 kgf-m, 81.1 ft. lbs.)
Rear Drive Shaft Disassembly
DISASSEMBLY
1. Straighten the bent claw at the larger end of the DOJ boot.
2. Loosen the band by means of screwdriver or pliers.
CAUTION: Be careful not to damage the boot.
3. Remove the boot band on the small end of DOJ boot in the same manner.
4. Remove the larger end of DOJ boot from DOJ outer race.
5. Pry and remove the round circlip at the neck of DOJ outer race with a screwdriver.
6. Take out the DOJ outer race from the shaft assembly.
7. Wipe off the grease and take out the ball bearings.
CAUTION: The grease is a special grease (grease for constant velocity joints). Do not mix with other greases.
NOTE: Disassemble exercising care not to lose balls (6 pcs).
