Outback F4-2.5L DOHC Turbo (2006)
8. To remove the cage from inner race, turn the cage by a half pitch to the track groove of inner race and shift the cage.
9. Using pliers, remove the snap ring fixing the inner race to the shaft.
10. Take out the DOJ inner race.
11. Take off the DOJ cage from shaft and remove the DOJ boot.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
12. Remove the BJ boot or EBJ boot in the same procedure as the DOJ boot.
NOTE: Further disassembly of axle is impossible because the BJ and EBJ cannot be disassembled.
Rear Drive Shaft Assembly
ASSEMBLY
NOTE: Use specified grease.
BJ side: NTG2218-M (Part No. 28395AG01A)
EBJ side NTG2218-M (Part No. 28395AG01A)
DOJ side: NKG205 (Part No. 28495AGOOA)
1. Install the BJ or EBJ boot in specified position, and fill it with 60 to 70 g (2.12 to 2.47 oz.) of specified grease.
2. Place the DOJ boot at the center of shaft.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
3. Insert the DOJ cage onto shaft.
NOTE: Insert the cage with the cutout portion facing the shaft end, since the cage has an orientation.
4. Install the DOJ inner race on shaft and fix the snap ring in place with pliers.
NOTE: Confirm that the snap ring is completely fitted in the shaft groove.
