Outback F4-2.5L SOHC (2005)
6. Place alignment marks on the roller kit and trunnion.
7. Remove the roller kit from trunnion.
CAUTION: Be careful with the roller kit position.
8. Place alignment marks on the trunnion and shaft.
9. Remove the snap ring and trunnion.
CAUTION: Be sure to wrap shaft splines with vinyl tape to prevent boot from scratches.
10. Remove the PTJ boot.
NOTE: Further disassembly of axle is impossible because the BJ cannot be disassembled.
Rear Drive Shaft Disassembly
Rear Drive Shaft
DISASSEMBLY
1. Straighten the bent claw of larger end of DOJ boot.
