Outback F6-3.0L DOHC (2006)
NOTE: Do not tilt the sash bracket to inner panel during adjustment.Otherwise smooth regulator operation cannot be achieved.
11. Make adjustment of front sash in the same manner as that of rear sash.
NOTE: Although front and rear sashes must, as a rule, be adjusted in the same manner, in some door installation, the adjustment in a different
manner may be required. However, adjustment of one sash to the maximum amount and the other to the minimum amount is not permitted. Such
adjustment may result in application of excessive load to regulator.
12. After adjustments, tighten the nuts.
13. After adjustment of the glass, close the door. If there is a gap between outer lip of gusset and glass surface, adjust the gap with adjusting bolt (A)
in lower fitting part of gusset to prevent generation of wind noise.
14. During adjustment, loosen the other three clamping bolts.
15. After adjustment, tighten the bolts and nuts.
