Outback F6-3.0L DOHC (2006)
^
Do not drop or bump the VDCCM&H/U.
^
Do not turn VDCCM&H/U upside down or place it sideways for storage.
^
Be careful that no foreign objects are mixed in VDCCM&H/U.
^
Be careful that no water enters connectors.
8. Remove the VDCCM&H/U bracket.
INSTALLATION
1. Install the VDCCM&H/U bracket.
Tightening torque: 33 Nm (3.3 kgf-m, 24 ft. lbs.)
2. Install the VDCCM&H/U to bracket.
3. Install the clip.
NOTE: Hook the clip on the pawl of bracket securely.
4. Connect the brake pipes to their specified VDCCM&H/U positions.
5. Connect the connector to VDCCM&H/U.
NOTE:
^
Be sure to remove all foreign matters from inside the connector before connecting.
^
Ensure that the VDCCM&H/U connector is securely locked.
6. Connect the pressure sensor connector.
7. Bleed air from the brake system.