Outback F6-3.0L DOHC (2006)
CAUTION: Do not damage the cylinder and piston seal groove.
6. Remove the guide pin and boot from caliper body.
16-INCH TYPE
Refer to 15-inch type.
17-INCH TYPE
Refer to 15-inch type.
ASSEMBLY
1. 15-INCH TYPE
1. Clean the caliper body interior using brake fluid.
2. Apply a coat of brake fluid to the piston seal and fit piston seal in groove on caliper body.
3. Apply a coat of brake fluid to the entire inner surface of cylinder and outer surface of piston.
4. Apply a coat of specified grease to the boot and fit in to the groove on the ends of cylinder.
Grease: NIGLUBE RX-2 (Part No. K0779GA102)
5. Insert the piston into cylinder.
CAUTION: Do not force the piston into cylinder.
