Outback F6-3.0L DOHC (2006)
4
Attach a rod of less than 12 mm (0.47 inch) diameter to the shaded area of the brake pad, and strike the rod with a hammer to drive brake pad
out of place.
16-INCH TYPE
Refer to 15-inch type.
17-INCH TYPE
Refer to 15-inch type.
INSTALLATION
15-INCH TYPE
1. Apply a thin coat of Molykote M7439 to pad clip.
2. Apply a thin coat of Molykote AS880N (Part No. K0779YA010 to the frictional portion between pad and pad inner shim.
3. Apply a thin coat of Molykote AS880N (Part No. K0779YA010 to the three frictional portions between inner shim and outer shim of outer pads.
4. Install the pad on support.
5. Install the caliper body on support.
Tightening torque: 27 Nm (2.8 kgf-m, 19.9 ft. lbs.)
16-INCH TYPE
Refer to 15-inch type.
17-INCH TYPE
