Outback F6-3.0L DOHC (2006)
5. After replacing the O-ring with a new one, install the master cylinder to brake booster.
6. Connect the brake pipes to master cylinder.
7. Connect the connector for brake fluid level gauge.
8. Measure the clearance between the threaded end of stop light switch and stopper.
If it is not within specified value, adjust it by adjusting the position of stop light switch.
CAUTION: Be careful not to rotate the stop light switch.
9. Apply grease to the operating rod connecting pin to prevent it from wearing.
10. Bleed air from the brake system.
Tightening torque (Air bleeder screw): 8 Nm (0.8 kgf-m, 5.8 ft. lbs.)
11. Conduct road tests to ensure brakes do not drag.
