Outback F6-3.0L DOHC (2006)
Electronic Brake Control Module: Service and Repair
With ABS
ABS Control Module and Hydraulic Control Unit (ABSCM & H/U)
ABS CONTROL MODULE AND HYDRAULIC CONTROL UNIT (ABSCM&H/U)
REMOVAL
1. Disconnect the ground cable from battery.
2. Use compressed air to remove water and dust around the ABSCM & H/U.
NOTE: If the terminals become dirty, it may cause improper contact.
3. Lift the lock lever and disconnect the ABSCM & H/U connector.
CAUTION: Do not pull on the harness when disconnecting the connector.
4. Remove the harness clip.
5. Disconnect the brake pipes from the ABSCM & H/U.
6. Wrap the brake pipe with a vinyl bag so as not to spill the brake fluid on the vehicle body.