Outback F6-3.0L DOHC (2006)
11. Tighten the bolts which hold the hose bracket.
Tightening torque: 10 Nm (1.02 kgf-cm, 7.4 ft. lbs.)
12. Install the air intake duct.
13. Connect the battery ground cable to battery.
14. Feed the specified fluid.
CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.
15. Finally, check clearance between pipes or hoses as shown in the figure indicated in General Diagnostic Table.
INSPECTION
Check all disassembled parts for wear, damage or other abnormalities. Repair or replace defective parts as necessary.
CAUTION:
Although surface layer materials of rubber hoses have excellent weathering resistance, heat resistance and resistance for low temperature brittleness,
