Outback F6-3.0L DOHC (2006)
8. Remove the front hub unit bearing. If it is hard to remove, use the ST.
ST1 926470000 AXLE SHAFT PULLER
ST2 28099PA110 AXLE SHAFT PULLER PLATE
INSTALLATION
1. Place the disc cover between housing and front hub unit, and tighten the four bolts.
Tightening torque: 65 Nm (6.6 kgf-m, 47.9 ft. lbs.)
2. Install the front drive shaft.
3. Tighten the axle nut temporarily.
4. Install the disc rotor to hub.
5. Install the disc brake caliper on the housing.
Tightening torque: 80 Nm (8.2 kgf-m, 59 ft. lbs.)
6. While depressing the brake pedal, tighten a new axle nut (olive color) to the specified torque and lock it securely.
Tightening torque: 220 Nm (22.4 kgf-m, 162 ft. lbs.)
CAUTION:
^
Install the wheel after installation of axle nut. Failure to follow this rule may damage the wheel bearing.
^
Be sure to tighten the axle nut to specified torque. Do not overtighten it as this may damage the wheel bearing.
7. After tightening the axle nut, lock it securely.
